[. . . ] 45 Adjusting the brightness of the touch screen, lamps, and other indicators . 33 2 Owner’s Manual The above warning is located on the rear/side of the unit. l’avertissement ci-dessus est situé sur le arrière/côté de l’appareil. Explanation of Graphical Symbols Explication des symboles The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. [. . . ] The B1, B2, B3, and B4 keys in the Fader Bank section enable you to assign and recall a bank with your own assortment of the channels or DCA groups. € Since the custom fader banks enable you to assign a combination of different types of channels, you can control different types of channels as a group. The channel strip is divided into 1–16, 17–24 (QL5 only), and Master, from the left side of the console. Press the appropriate Bank Select key (in the FADER BANK section) of the bank containing the channel that you want to control. Select one of the preset or custom fader banks in the Channel Strip section. The SELECTED CHANNEL VIEW screen for the selected channel will appear. Use the knobs of the Selected Channel section and the buttons in the SELECTED CHANNEL VIEW screen to edit the parameters of the selected channel. Even if a different screen is selected, the currently-selected channel can be set using the knobs of the Selected Channel section. In this case, a mini window indicating the value of that parameter will appear on screen when you operate a knob. Press the Fader select button you want to set, then press the [SEL] key for the channel that you want to assign to that fader. Press the button below the desired number to display the CH SELECT screen. Use the list in the left column to select the desired channel group, then use the buttons in the right column to select channels. When you have finished, press the X symbol in the upper right corner of the screen, and press the SETUP button again to return to the SELECT CHANNEL VIEW screen. Repeat steps 1–3 to adjust the send level for other MIX/MATRIX buses in the same way. When you’ve finished setting the MIX/MATRIX send levels, press the key that is flashing in the SENDS ON FADER section. The function access area display will return to its prior state, and the unit will return to normal mode. NOTE You can also use the buttons in the function access area to switch and select buses. 1 ON FADER switch button Pressing this button repeatedly will switch between MIX and MATRIX. 2 MIX/MATRIX bus select buttons These buttons enable you to select the destination MIX/MATRIX buses. Adjusting the send level to a MIX bus or MATRIX bus (SENDS ON FADER mode) Each fader on the top panel enables you to adjust the level of the corresponding channel, as well as the send level of the signal routed from each channel to the specified MIX/MATRIX bus (SENDS ON FADER mode). Press the key for the MIX/MATRIX bus to be used to adjust the SENDS ON FADER section. 2 Assigning a name On the QL series, you can assign a name to each input channel, output channel, DCA group, and MUTE group, and assign a title to scene and library data when saving it. [. . . ]  When formatting the USB flash drive , format it in FAT32 or FAT16 format. ρ Could FOCUS be set in such a way that the channels or parameters will not be updated?You turn on a CUE button in the EFFECT EDIT screen, but it is automatically defeated. ρ This is defeated automatically when you switch screens in the display. [. . . ]